Instructions
Create a 3D model of the step block. Your model must directly reflect the design intent indicated in the drawing. That is, only use dimensions from the print to drive your geometry.
Turn in TWO types of files.
- An NX part file with filename: HW02A_UUID.prt
- Screenshots showing the following:
- Your part navigator structure
- Your properly defined sketch
Notes
If you are unfamiliar with the term “orthographic projection” be sure to see this link from TECH 1521.
There is a commonly used manufacturing process called “extrusion.” This is where the name for this kind of sweep comes from. Be sure you are familiar with both uses of the term. Aluminum Extrusion Video.
