Knife Stop


To introduce students to the concept of parametric solid modeling in general and the NX operating environment in particular.

To give students an introduction to feature-based (CGS) modeling.

To introduce students in this course to the integrating product.


Please see the following link: Integrating Product Notebook and read the introduction.

Part Definition: M01-080

Your first task is to model the knife stop (M01-008) from scratch.  Your model must use expressions for the diameter and the length.

Save your work in your directory under a sub-directory named KNIFE_STOP.

The model must be accurate.  It should contain only one solid body, and the model origin 0,0,0 must be the bottom center of the cylinder.






Leave a Reply

Your email address will not be published. Required fields are marked *

Scroll to Top